Bonnet cables shuttle housing

steve-45 · 30th December 2020, 22:44

Found an old article where someone was making uprated housings, using a PA12 polymer material and probably using a 3D printer.

Does anyone know if anything came of this and were they any good?

Arctic · 31st December 2020, 08:45

Quote:

Originally Posted by steve-45

Found an old article where someone was making uprated housings, using a PA12 polymer material and probably using a 3D printer.

Does anyone know if anything came of this and were they any good?

Hi Steve.
I think this is the link you are looking for.

https://the75andztclub.co.uk/forum/s...d.php?t=305373

https://the75andztclub.co.uk/forum/s...2792318&nojs=1

https://the75andztclub.co.uk/forum/a...3&d=1581282105

rab60bit · 31st December 2020, 15:26

Quote:

Originally Posted by steve-45

Found an old article where someone was making uprated housings, using a PA12 polymer material and probably using a 3D printer.

Does anyone know if anything came of this and were they any good?

Arctic has found the link. I got one whilst they were still available (not too expensive) and a cheap do if you get the locked bonnet gremlins caused by a neglected OEM shuttle!
Not fitted it yet because my nano 'upgraded' original one is working fine after a complete clean/lubrication and a new set of cables - should it fail in the future I'll use the Ez-Zee job because it certainly looks the dogs do da's

Bob Walker · 17th March 2021, 18:19

I've made a batch of shuttle box covers/brackets in stainless that will make sure it never comes off unless you want it to! If you want to see a picture please send me a PM.

30th December 2020, 22:44	#1
steve-45 This is my second home Rover 75 Saloon CDTi Join Date: Oct 2015 Location: Belvedere Posts: 4,076 Thanks: 108 Thanked 1,089 Times in 774 Posts	Bonnet cables shuttle housing Found an old article where someone was making uprated housings, using a PA12 polymer material and probably using a 3D printer. Does anyone know if anything came of this and were they any good?

17th March 2021, 18:19	#4
Bob Walker Loves to post MGZT Join Date: Aug 2019 Location: Richmond Posts: 255 Thanks: 26 Thanked 80 Times in 45 Posts	Shuttle box I've made a batch of shuttle box covers/brackets in stainless that will make sure it never comes off unless you want it to! If you want to see a picture please send me a PM.