|
||
|
6th December 2020, 16:57 | #11 | |
Avid contributor
MG-ZTT Join Date: Oct 2020
Location: Cullercoats
Posts: 117
Thanks: 81
Thanked 69 Times in 47 Posts
|
Quote:
Reading the original post properly is probably better than jumping in feet first The OP owned a car previously which had been XPower upgraded, so 129 BHP, not unlike my own. He then went on to say his previous car gave you a kick in the pants over a certain rev range which you said would be likely a MAF sensor fault, well that might be the case, it certainly wasn't when it came to my car though it was a defective EGR causing the fault, which was masked when unplugging the MAF sensor. So after this fault was diagnosed correctly by someone with a lot of experience of these cars, the symptoms all disappeared when I took the garage's advice as to the root cause. My car now runs beautifully with smooth power delivery across the rev range, a bit like the OP's new car. So digging a little deeper you will find the new car was previously looked after by Phil-T4, a man with some standing on the forum, so it's quite likely the OP's car has had Phil's expert eye cast over it, and the usual foibles of the diesel sorted out. Now to the slightly distasteful aspect of this post, and it would appear many others that you make, every time a thread like this is posted on the forum, you immediately jump in with how wonderful your product is as compared to another. This smacks of desperate marketing, something that should be avoided at all costs. When I visit a pub or club to speak to the landlord about siting my equipment I never under any circumstances decry the incumbent supplier irrespective of poor service, poor quality equipment etc. What you find if you do, then people will often question your intent. Now I'm not saying this will be the case always, but if it is then word will travel quickly within the licenced trade. Back to the here and now, this forum is a very intimate environment in as much as many of your prospective customers will be members here, and by usage of marketing strategies that are so obviously biased against your competition then you are likely to be judged upon those actions. I have no axe to grind either way, I have no intention whatsoever of having my car upgraded, be that a 160 remap, or a custom remap as I'm perfectly happy with the car as it came from the factory. However if I were, I would not be making use of the services offered by a trader that uses a policy of talking down the opposition in favour of their own product Alf |
|
6th December 2020, 17:07 | #12 | |
Posted a thing or two
Alpina D3 Join Date: Sep 2014
Location: Cheslyn hay
Posts: 1,002
Thanks: 58
Thanked 294 Times in 227 Posts
|
Quote:
The 160 map is better than stock, and it isn't a bad map, it will do for most people, I'm just saying that there are more powerful maps out there. If you want a moderate increase of driveability, go for it. If you want maximum power (which some people don't want) then there are other maps available. Feel free to come to a Nano meet when they are back on if you wish to speak to me in person, I can show you how remapping works and the values that are altered and what things can be altered in a map. You've mentioned your EGR before on a post. It is typically the MAF sensor that causes a loss of low end power and what feels like turbo kick, not always, but it normally is. Unplugging the maf takes like 10 seconds and is easy to test. |
|
6th December 2020, 17:51 | #13 | |
Avid contributor
MG-ZTT Join Date: Oct 2020
Location: Cullercoats
Posts: 117
Thanks: 81
Thanked 69 Times in 47 Posts
|
Quote:
Unplugging the MAF takes 10 seconds? and unplugging the MAF disables the EGR. John told me the most common misconception people make when faced with the symptoms of a lack of power under 2000 RPM was to suspect the MAF, when in fact nine times out of ten it is a problem with the EGR. He demonstrated this to me in real time, explained the cause and the fix....job done. Back to your sales pitch, that is the reason I commented Jamie You can have the best product in the market, however if you need to resort to talking down the opposition then it's never going to be as good as you claim it to be I see you own several BMW models, I've had a few of those in the past including a rather nice 850 Ci coupe I bought new in 1992. That was a rapid car, I spotted one driving around locally and soon after headed to the showroom and treated myself. This car propelled me along at a respectable pace, having the M70B50 under the bonnet. The point being this, I drive a ZT-T because I'm less likely to have the thing keyed, or otherwise vandalised while parked outside a pub, plus my customers don't get the wrong sort of impressions based upon the type of car I'm driving at the time......that say for instance turning up in a Porsche 911 might convey I've been in business for a long time, profitably I may add, and one thing I've learned is to make progress you don't slate the opposition either publicly or privately, and to do so shows a distinct lack of business acumen. Alf |
|
6th December 2020, 18:02 | #14 | |
Posted a thing or two
Alpina D3 Join Date: Sep 2014
Location: Cheslyn hay
Posts: 1,002
Thanks: 58
Thanked 294 Times in 227 Posts
|
Quote:
I'm talking down the opposition because their numbers aren't correct. Find me a 160 mapped car, and let me see it on a dyno in person and I will be quiet if it hits 160bhp. I've spoken to a few people who have put 160 mapped cars on different dynos and seem to get around 140-145bhp. Like I said, it is an improvement over stock, but more power can be had. People on here are too complacent and just believe what certain people say to be the truth. Last edited by Jamiewelch; 6th December 2020 at 18:04.. |
|
6th December 2020, 18:25 | #15 | |
Avid contributor
MG-ZTT Join Date: Oct 2020
Location: Cullercoats
Posts: 117
Thanks: 81
Thanked 69 Times in 47 Posts
|
Quote:
Jamie I don't care whether you can make my car produce 500 BHP for ten pence, you miss the point I'm trying to make You do not get on in the business world by talking down the opposition, it's a really simple concept that has seen me in good stead in many years in business, by the way my business was established in 1968 after the Gaming Act of 1967 was enacted to counter the sort of practices made popular by the likes of Vince Landa and Michael Luvaglio......I'll let you google those names By the way sending immature private messages to me regarding other traders only reinforces the opinion that is forming about the way you conduct yourself, and that is not in a good way I'm afraid. Not good at all. Alf |
|
6th December 2020, 21:20 | #16 | |
This is my second home
Rover 75 Saloon & Tourer Join Date: Sep 2012
Location: Lincoln
Posts: 14,892
Thanks: 1,630
Thanked 3,032 Times in 2,181 Posts
|
Quote:
macafee2 |
|
7th December 2020, 00:08 | #17 |
Regular poster
Rover 75 Tourer Join Date: Dec 2019
Location: Sheffield
Posts: 90
Thanks: 64
Thanked 16 Times in 11 Posts
|
Chaps, to be clear, the new car delivers very smoothly and I havn't tried it yet on the only road where I ever seem to have a need for get up an go - the Snake, where I don't want to follow the sort of driver that brakes down to 30 on every bend and puts his (or her, let's not be 'ist about it) foot down again to the legal 50 on every straight. My old car, which was bought cheap and, to be honest, was as rough as a badgers' rough bits did however show a turn of "oomph" when asked. It just delivered in the manner of a 1980s-style turbo. I couldn't care less what the figures are on a rolling road I just "think" the car would be improved with a bit more "get up and - gone" on the few occasions that I ask it to, but not at the expense of pushing it to the limit, reliability, or day-to-day driving. I had a diesel mondeo a few years ago that was quick enough but the powerband was about as wide a fag paper. I also had a non-turbo escort van and you had to plan your overtakes in that with a calendar so my badly phrased question was simply trying to eek out any compromises that might have to be made is diverging from "factory".
Last edited by Scimdaz; 7th December 2020 at 00:10.. |
7th December 2020, 01:15 | #18 | |
I really should get out more.......
75 CDT SE 160 Saloon Join Date: May 2017
Location: Thorpe St Andrew, Norwich
Posts: 2,631
Thanks: 1,386
Thanked 1,096 Times in 774 Posts
|
Quote:
The company i work for make it clear that none of it's staff should denigrate the opposition and if you get caught doing so to make a sale then you are likely to get hauled up to explain yourself. It has earnt it's reputation through hard work and fair trading to the extent we rarely advertise as most of our business comes through recomendation and repeat customers.
__________________
Glutton for punishment --- Previously ... 2.6 SD1 x 2, 3.5 SD1, 820S, 820Si x2, 216 Gsi, 220T saloon, 414, 45 1.4 x2 and now a Cowley 75 CDT |
|
7th December 2020, 07:47 | #19 | |
Posted a thing or two
Alpina D3 Join Date: Sep 2014
Location: Cheslyn hay
Posts: 1,002
Thanks: 58
Thanked 294 Times in 227 Posts
|
Quote:
|
|
7th December 2020, 08:31 | #20 | |
This is my second home
Rover 75 Saloon & Tourer Join Date: Sep 2012
Location: Lincoln
Posts: 14,892
Thanks: 1,630
Thanked 3,032 Times in 2,181 Posts
|
Quote:
I have a 160 remap, my car is insured as if it has 160 BHP, if it has 140 BHP I am not sure I am bothered as the car goes well enough for my driving style and pulls the caravan along so much better which was the reason for a remap.... mind you a CDT needs something to help it along macafee2 |
|
Thread Tools | |
Display Modes | |
|
|