Go Back   The 75 and ZT Owners Club Forums > The 75 and ZT Owners Club Forums > I.C.E. Forum > Sat Nav Hardware & Software > Factory Fit Highline & Lowline Navigation Systems
Register FAQ Image Gallery Members List Calendar Search Today's Posts Mark Forums Read
Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 30th September 2020, 23:49   #1
75er
Avid contributor
 
Rover 75 Connie SE Tourer cdti

Join Date: Jun 2008
Location: Plymouth
Posts: 150
Thanks: 29
Thanked 25 Times in 19 Posts
Default SAt Nav cable connector repair

My highline navigation is not picking up a signal from the shark fin. I have replaced the sharkfin but still no signal. Looking at the connector that comes down from the sharks fin and into the sat nav drive in the boot I notice the co-axial cable, while still attached, has come loose from the connector which goes into the sat nav drive unit and I think its this that is causing the problem. I think the connector is an SMB connector? The connector are readily available, but the crimping tool for the SMB connector is over £100. A bit expensive for 1 crimp! Can anyone confirm that it is a SMB connector (not an SMA) to the Sat Nav unit and has anyone had experience of repair /replacing this connector? Thanks.
75er is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 12:04.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright © 2006-2020, The Rover 75 & MG ZT Owners Club Ltd