Kv6 fuel feed pipe to injection rail ? - Page 3

vitesse · 19th April 2021, 17:52

Quote:

Originally Posted by Shuriken_57

Hello, can you tell me where can i found a dismantler on the forum please ?
Thanks you , it is difficult to find a Rover 75 v6 here in France.

Well MickeyBoy is a dismantler, Exeter Road Garage too, both are traders here but
I haven't had much luck getting replies from either. Perhaps non-UK members are too much trouble, but even pre-Brexit it didn't make much difference

Have you tried the "wanted" section? Some members are extremely helpful and in my experience a better option.

Good luck

SJPeppers · 20th April 2021, 09:37

I recently had the same issues (MG ZS180 KV6). Managed to bend the clip back in to shape, held on to the o rings and spacer but wanted to renew the o rings.

Found the spacer for sale here along side the o rings and many other parts for the KV6 injection system https://www.ebay.co.uk/itm/Rover-75-...8AAOSwY1JgCXQP

Shuriken_57 · 20th April 2021, 15:29

Quote:

Originally Posted by SJPeppers

I recently had the same issues (MG ZS180 KV6). Managed to bend the clip back in to shape, held on to the o rings and spacer but wanted to renew the o rings.

Found the spacer for sale here along side the o rings and many other parts for the KV6 injection system https://www.ebay.co.uk/itm/Rover-75-...8AAOSwY1JgCXQP

My clip is broken , i can't replace the fuel pipe. I don't now where can i found this clip

SJPeppers · 21st April 2021, 07:32

Sorry, I read the OP. As maybe previously mentioned I think the clip comes as part of the fuel rail. Maybe best looking out for a second hand rail. Otherwise some of the Dorman fuel line retaining clips look similar but it would be a long shot if they fit. Also a jaguar one which looks similar. Might be worth trying to check measurements.

20th April 2021, 09:37	#22
SJPeppers Newbie MG ZS180 Join Date: Mar 2021 Location: Peel Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts	I recently had the same issues (MG ZS180 KV6). Managed to bend the clip back in to shape, held on to the o rings and spacer but wanted to renew the o rings. Found the spacer for sale here along side the o rings and many other parts for the KV6 injection system https://www.ebay.co.uk/itm/Rover-75-...8AAOSwY1JgCXQP

21st April 2021, 07:32	#24
SJPeppers Newbie MG ZS180 Join Date: Mar 2021 Location: Peel Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts	Sorry, I read the OP. As maybe previously mentioned I think the clip comes as part of the fuel rail. Maybe best looking out for a second hand rail. Otherwise some of the Dorman fuel line retaining clips look similar but it would be a long shot if they fit. Also a jaguar one which looks similar. Might be worth trying to check measurements.