Sills and arches, had to have a bit of work done - Page 2

p2roverman · 6th November 2021, 15:17

Dave Stocktake.
Thanks for posting these photos. My latest acquisition is in the same condition. I'll be making a repair panel to go up the wheel arch, and will also need a similar length of repair to the inner arch.
I have one of Tom's jacking points to fit after replacement of a section of the inner sill.
I'll be making a full length outer sill from one of Tom's panels and 3/4 length of original pressing available from ebay until recently, decided to make the join where my welding will be hidden by the chrome strip.
One request - I need a front jacking point and surrounding steel if anyone can cut a good one from a scrap shell.

6th November 2021, 15:17	#11
p2roverman Gets stuck in Rover 75 Connie Tourer & Connie SE Saloon & Club SE Tourer Join Date: Sep 2014 Location: Leeds Posts: 975 Thanks: 199 Thanked 71 Times in 59 Posts	Dave Stocktake. Thanks for posting these photos. My latest acquisition is in the same condition. I'll be making a repair panel to go up the wheel arch, and will also need a similar length of repair to the inner arch. I have one of Tom's jacking points to fit after replacement of a section of the inner sill. I'll be making a full length outer sill from one of Tom's panels and 3/4 length of original pressing available from ebay until recently, decided to make the join where my welding will be hidden by the chrome strip. One request - I need a front jacking point and surrounding steel if anyone can cut a good one from a scrap shell.