My end of ERA sale:

[DennisA]

As my pride & joy has now departed I am selling off various items from my garage - my car was a R75 2.0 CDTi Conn SE auto 12/2003 so all specific items are for diesels. All are new unless otherwise stated.

1 x MGR Top Hydramount KKB101923, this is new and still in box - £50 posted
1 x Hydramount Tool for easier removal of the above - £30 posted
(Will sell both the above together £75 posted)

1 x Magnetti Marelli "In Tank" fuel pump (MAM00081), together with new tank/pump seal, all new and still in box - £30 posted.
1 x Magnetti Marelli " Under Bonnet" pump (MAM00084), new and still in box - £30 posted.

1 x Set Pagid hand brake shores (H9605) together with set of springs and pins, all new and in box - £20 posted.

1 x Set Mintex MDB2011 Front brake pads, new still in box - £12 posted.
1 x Set MintexMDB 1888 rear pads, these are not new but only on car for less than 1k as I then worked on rear suspension and changed rear discs with new pads - I'll put them in with the above front pads for - £18 posted the lot.

1 x Continental aux. drive belt - £12 posted.
1 x Veco aircon. drive belt - £6 posted
(I will sell both belts together for £15 posted)

2 x Vitron O rings seals for air cooler pipe - £3 posted

1 x Starter motor solenoid repair kit with instructions - £10 posted

1 x E-Zee gold 100w fasn resister - £10 posted

1 x E-Zee OBD service interval resetting tool with instruction (Magic box with button on the end - simples!). - £5 posted.

1 x MGR rear brake wear sensor cable - £7 posted.

1 x Silicon air intake pipe, this used but in excellent condition (As arrange with supplier by Wullie over the club forums).The pipe between air cooler and EGR, older type continuous pipe without added sensor in the middle, but could be cut to suit? - £20 posted.
1 x EGR bypass replacement EGR, this is used but in good condition. £18 posted.
(I would sell both the above together for £35 posted).

I have other items but not sorted them out yet, I will place them on here with prices as soon I have checked them.

1 x Brink detatchable towbar with full twin electrics kit, all wiring is still there as I cut it out from the Orange/Grey wire under glove box, plus full instructions - but due to size and weight delivery would have to be discussed!

1 x FBH with rear fuel pump and Maplin remote start kit, with bracket exhaust full instructions.

1 x Headlamp washer kit, including pipes, jets and washer pump, I also have a heater washer jets kit but this was cut off short of the plug under the o/s wing so I would include this as a job lot with the headlamp washers.

4 x 18" Hairpin wheels with original rover centre caps (My R75 came with these from new). Not brilliant condition after 13 ears but OK. Tyre treads are OK but I have notice some crazing on the side walls so will look into this before listing. Delivery of these would need to be discussed.

4 x 16" Unions in fairly good condition, will check them more closely before listing. Delivery would have to be discussed.

I am open to reasonable offers on all items above, both those with prices and others I am still getting sorted, but please be sensible I am not a fool and don't suffer those that are easily!

Brgds Dennis

[Walter]

I will take Hydromount and tool please -paypal OK ?

[DennisA]

Certainly Walter,

I will PM you my paypal account please reply with your address and will send them on as soon as money is received.

Brgds Dennis

[Walter]

Originally Posted by DennisA

Certainly Walter,

I will PM you my paypal account please reply with your address and will send them on as soon as money is received.

Brgds Dennis

Payment sent along with address

[ryszard]

Hi Dennis,if still available can I have the silicone air intake pipe please.Regards Ryszard..

[DennisA]

Hi Ryszad,

Did you want it with or without the EGR Bypass?

Brgds Dennis

[ryszard]

Hi,without the EGR by pass please.But out of curiousity is it a stainless steel one, if so I may be interested. Also while I think about it i will take the starter motor solenoid repair kit with instructions if available.Regards Ryszard...

[Dawn]

Does anyone know if the towbar would fit a facelift V6, or are they different for the Mk2?

[Rev Jules]

Hi could you pm me cost of the FBH kit please.

Rev

[Rooney]

Originally Posted by Dawn

Does anyone know if the towbar would fit a facelift V6, or are they different for the Mk2?

They're identical Dawn.