|
||
|
11th February 2019, 20:33 | #1 |
Gets stuck in
MG-ZT Cdti 131 Join Date: Nov 2006
Location: Poole
Posts: 676
Thanks: 92
Thanked 111 Times in 98 Posts
|
Reversing sensors, not the normal story.
My ZT 2003 Auto reversing sensors are playing up. I have read the HowTo but it does help in my case.
When I first start the car and put it into reverse I get a constant tone, if I take it out of reverse and then put it back in 9/10 times I get normal sensors. I have checked each sensor and they are all clicking, two sensors do have paint delamination in the middle. Any ideas?? |
11th February 2019, 20:47 | #2 |
Premium Trader
Rover 75 Join Date: Nov 2010
Location: Devon
Posts: 33,769
Thanks: 8,837
Thanked 14,831 Times in 8,030 Posts
|
Check the wiring harness behind the bumper, these have been known to break causing your issue.
__________________
Lest we forget..
|
11th February 2019, 21:03 | #3 |
Gets stuck in
MG-ZT Cdti 131 Join Date: Nov 2006
Location: Poole
Posts: 676
Thanks: 92
Thanked 111 Times in 98 Posts
|
|
11th February 2019, 21:14 | #4 |
Premium Trader
Rover 75 Join Date: Nov 2010
Location: Devon
Posts: 33,769
Thanks: 8,837
Thanked 14,831 Times in 8,030 Posts
|
Its easier with the bumper off, two plastic fasteners under the centre of the bumper, five more when you open the boot, then a self tapper at each side of the rear wheel arch, then a firm pull on each side and the bumper will be off.
__________________
Lest we forget..
|
11th February 2019, 21:46 | #5 |
Avid contributor
Rover 75 Saloon Join Date: Apr 2012
Location: Nantwich
Posts: 151
Thanks: 260
Thanked 41 Times in 34 Posts
|
Hi.
Clean the paint that has delaminated off. Mine did the same, I cleaned up and painted the sensor been OK since. Kev |
|
|