Zt Boot badge mount

ceedy · 31st May 2020, 10:34

Any body got a picture of the back/inside of a Zed boot badge mount .

Not the octagonal one under the Lippy spoiler. the other top badge type .

Tryong to get mine off the boot to mount a camera on the 260 but a nut is just spinning , so little chance of getting the mount off and hoping it can just drill a hole or 2 in to get a cable through into the boot lid .

this type

ta

Chris

ceedy · 31st May 2020, 12:16

Sorted....

Had to grind off the nut with my dremel .barely any room in through the few holes .

Found the floating stud had been overtightned and broken its fixing point.

Alslo water had got in and then made the stud rusty .

So out with the Araldite to fix the stud in.. and now can figure out where to put the camera cable .

Reckon this was overtightened at the factory and also found there are a few signs of failed attempts to get the moulding off under the gasket edges

c.

31st May 2020, 10:34	#1
ceedy This is my second home All Trophy Blue ,ZT260#50 , ZT CDTI Auto, ZR105+ and 1.8T Firefrost spoiling the Set . Join Date: Nov 2006 Location: Nr Sherborne But in Somerset.. Posts: 6,076 Thanks: 916 Thanked 1,214 Times in 768 Posts	Zt Boot badge mount Any body got a picture of the back/inside of a Zed boot badge mount . Not the octagonal one under the Lippy spoiler. the other top badge type . Tryong to get mine off the boot to mount a camera on the 260 but a nut is just spinning , so little chance of getting the mount off and hoping it can just drill a hole or 2 in to get a cable through into the boot lid . this type ta Chris __________________ The Three Bloo's Wifey's Zr105, MY CDTI & 260 #50 and Number One sons 1.8T in Firefrost When I were a lad Zero to 142 in 10.25 secs at the Pod on my Blown Norton. 210 Kart Champ in 70's

31st May 2020, 12:16	#2
ceedy This is my second home All Trophy Blue ,ZT260#50 , ZT CDTI Auto, ZR105+ and 1.8T Firefrost spoiling the Set . Join Date: Nov 2006 Location: Nr Sherborne But in Somerset.. Posts: 6,076 Thanks: 916 Thanked 1,214 Times in 768 Posts	Sorted.... Had to grind off the nut with my dremel .barely any room in through the few holes . Found the floating stud had been overtightned and broken its fixing point. Alslo water had got in and then made the stud rusty . So out with the Araldite to fix the stud in.. and now can figure out where to put the camera cable . Reckon this was overtightened at the factory and also found there are a few signs of failed attempts to get the moulding off under the gasket edges c. __________________ The Three Bloo's Wifey's Zr105, MY CDTI & 260 #50 and Number One sons 1.8T in Firefrost When I were a lad Zero to 142 in 10.25 secs at the Pod on my Blown Norton. 210 Kart Champ in 70's