|
||
|
10th May 2018, 09:18 | #1 |
Avid contributor
MG ZT-T Join Date: Jun 2011
Location: earl shilton
Posts: 230
Thanks: 4
Thanked 12 Times in 11 Posts
|
Windscreen washer blocked
Trying to sort out my windsreen washer which blocked. The filter isn't blocked, and pump sprays water when pipes are disconnected. It's not working for both the front and rear washers. Don't know if i have to replace the spray nozzles, but if so need heated ones, or is there anything i can put in to clear the blockage.
Also looking for hose connector for headlight washer as one has broken in half. |
10th May 2018, 09:27 | #2 |
Gets stuck in
None at the moment Join Date: Jan 2018
Location: Hereford
Posts: 501
Thanks: 1
Thanked 165 Times in 146 Posts
|
The fact its both front and rear, to me points to the pump, but you could disconnect the pipes at the pump and use an air line on each jet to back flush any blockage . Careful as it could blow the pipe off & then you would have to dismantle to reconnect.
|
10th May 2018, 09:35 | #3 |
Avid contributor
MG ZT-T Join Date: Jun 2011
Location: earl shilton
Posts: 230
Thanks: 4
Thanked 12 Times in 11 Posts
|
As previously stated the pump works with water pipes disconnected. Also don't have access to air hose to blow out pipes.
|
10th May 2018, 20:17 | #4 |
This is my second home
Rover 75 Saloon & Tourer Join Date: Sep 2012
Location: Lincoln
Posts: 14,912
Thanks: 1,630
Thanked 3,032 Times in 2,181 Posts
|
try putting a pin in the whole of the jet where water comes out, sometimes works.
Not sure if lime scale is the problem blocking the jet so try a lime scale remover. I think you can get ford heated jets that fit but you have to change the electrical connector macafee2 |
11th May 2018, 14:01 | #5 | ||
Give to Learn
Freelander 2 Join Date: Aug 2010
Location: West Midlands
Posts: 18,696
Thanks: 1,155
Thanked 6,407 Times in 3,874 Posts
|
Quote:
Remove the sound proofing to the underside of the bonnet and you will see a connector that will be your problem it will be blocked inside. I tried using a bike pump on mine to unblock it worked for a while in the end I changed if for another connector y shape bee great ever since. 1 2 3 4 5 In the end I used this below and worked ever since no blockages 6
__________________
Arctic Givology Learn to Give Everything is Achievable ad altiora tendo. Check out our Nano meet dates http://www.midlandsnanomeets.co.uk/ http://www.the75andztclub.co.uk/index.php?thepage=howto " You do the work , we supply the expertise " |
||
11th May 2018, 15:36 | #6 |
Avid contributor
MG ZT-T Join Date: Jun 2011
Location: earl shilton
Posts: 230
Thanks: 4
Thanked 12 Times in 11 Posts
|
Thanks will do this on tuesday
|
11th May 2018, 17:11 | #7 |
same car since 2005
2001 Rover 75 2.0 v6 Connoisseur Saloon Join Date: Nov 2006
Location: Ellesmere Port , Cheshire
Posts: 3,811
Thanks: 379
Thanked 549 Times in 466 Posts
|
__________________
Who said it was simples ? |
11th May 2018, 17:14 | #8 |
This is my second home
rover 75 1.8 vvc club se wedgwood blue Join Date: Aug 2009
Location: Seaton Carew
Posts: 26,912
Thanks: 65
Thanked 7,142 Times in 4,642 Posts
|
|
20th May 2020, 17:43 | #9 | |
Gets stuck in
R75 2.0 CDT Club SE Tourer Join Date: Oct 2013
Location: Manchester
Posts: 614
Thanks: 105
Thanked 101 Times in 89 Posts
|
Quote:
I knew the pump was ok because the rear washers were working fine. After peeling back the top of the soundproofing (those fixings are a pain to remove until you get the knack) I disconnected the supply tube from the 3-way connector and that was then pumping out as it should. So I took the 3-way off completely and connected the supply tube in turn to the 2 outlets and they were flowing between each other so it was clear that it was the bit in the centre that was the problem. Used the same Y-connector (from the Halfords box I got, again on your advice, when sorting the sun roof issue) and it's fine. The one little concern I have is that I think the white cap on the original 3-way is a non-return valve (and was jammed), which presumably is meant to stop the washer fluid flowing back down into the reservoir (and maybe also prevents muck going down there). |
|
23rd May 2020, 10:42 | #10 |
Avid contributor
Rover 75 Saloon Join Date: Jan 2015
Location: Guildford
Posts: 170
Thanks: 129
Thanked 48 Times in 21 Posts
|
Hi
Anyone got a part number for the Ford Focus jets? Cheers |
Thread Tools | |
Display Modes | |
|
|