|
||
|
11th May 2019, 16:58 | #11 | |
MG ZT Join Date: Jan 2011
Location: Newcastle Upon Tyne
Posts: 20,151
Thanks: 3,565
Thanked 10,837 Times in 5,718 Posts
|
Quote:
Then blade A will fit into case C Make sure you transfer the PCF7930AS chip from the old key back to part D, ensuring before the transponder gets lost because you are using a cheap casing, to place a blob of blu tac into the casing where the transponder sits. Then fit the remote board to case C, and clip rear case D to the case C part and ensure the remote pcb buttons both work, if not you will have to clean the moulding flash out of the casing to allow the buttons to work. And if you get stuck, you can order one of THESE and fit your electronics to the casing. Is that any clearer for you? Brian |
|
|
|