What I did with my Rover 75/MG ZT today? - Page 1251

Bogbrush82 · 4th April 2021, 22:58

Quote:

Originally Posted by trikey

Gradual build up I reckon Steve, the rear sunroof drain was blocked on the drivers side, I suspect that to be the cause, I have cleaned it out for now, will do the correct mod on all four when time allows.

And yes, its going to be a carpet out job, at least the good weather will be here soon

You only need to do 3 - Mine was done by Summit Garage a while back.

Arctic · 5th April 2021, 08:30

Quote:

Originally Posted by Bogbrush82

You only need to do 3 - Mine was done by Summit Garage a while back.

What is the reasoning behind that method please say Why?

Bogbrush82 · 5th April 2021, 21:36

Quote:

Originally Posted by Arctic

What is the reasoning behind that method please say Why?

My bad, I thought he meant all 4 cars.

It's just that since he was planning to do that to my old one I'd give him the heads up (Sold it to him last year).

sewerman · 5th April 2021, 22:13

Fit new rear lights to the tourer as the existing brackets were shot and the lenses chipped.

Drivers side no trouble, passenger side PIA the sockets were broke the spares i had didn't want to hold , hopefully sorted with some silicone to stick them in will see tomorrow .

Sent from my SM-G977B using Tapatalk

cbr1100xx · 6th April 2021, 14:36

Broke it , again

Stan

FLYING BANANA · 6th April 2021, 15:02

Took the Bear for a run over to the dark side and home via the go go juice station. Only took £48 to top up the tank. Took her home and swapped cars over.
Banana’s turn for some go go juice. Only the second time this year she has been into the go go juice station. And that was £42 to top up.

Plus Banana tripped over onto 211,000 miles.

sewerman · 6th April 2021, 19:13

Fixed the tourers nearside new lamp, noticed the bumper wheel arch screw was missing so sorted that, then while i was under the car noticed the heat shield had pulled past the bolt so fit a big washer to sort that too.

Sent from my SM-G977B using Tapatalk

Sheraton · 6th April 2021, 21:13

Picked up Ten Lengths of CLS Timber - 2.4m lengths via the Ski Hatch - a comfortable fit with room to spare for length, and relatively secure/safe

Paul.

Bob Walker · 9th April 2021, 07:34

I finally got around to replacing the thermostat and seals on my 190. I did it via the keyhole method a very kind and helpful member posted on this forum. The hardest part was bolting the thermostat and pipe back on the engine! 2 hours later I managed to do it! I have now got the feeling back in in my hand and arms, very little space to get hold of the bolt and the ratchet!! It is great to have a heater and no more evaporating coolant smells!! I tried not to drop the bleed valve when replacing the coolant, and guess what I did, dropped it!!

sewerman · 9th April 2021, 18:07

Fitted the powerflex lower engine mount and fitted a high tone horn much better sound ! Also booked the ZT in with Tom Hobbs to get the hole fixed

Sent from my SM-G977B using Tapatalk

6th April 2021, 14:36	#12505
cbr1100xx Gets stuck in VW touareg Join Date: Mar 2015 Location: dunsop bridge Posts: 870 Thanks: 225 Thanked 414 Times in 235 Posts	Broke it , again Stan __________________ WE WERE BOTH BORN ON THE 4th of JULY CAR DIED 15/11/2022---I'M STILL GOING (JUST)

6th April 2021, 15:02	#12506
FLYING BANANA Moderator/Club Shop MG ZT 1.8t+. No.3 of 4 in Sunspot Yellow & Ford Fiesta in Black. Join Date: Aug 2010 Location: Rattler Farm Posts: 22,548 Thanks: 9,270 Thanked 15,645 Times in 6,806 Posts	Took the Bear for a run over to the dark side and home via the go go juice station. Only took £48 to top up the tank. Took her home and swapped cars over. Banana’s turn for some go go juice. Only the second time this year she has been into the go go juice station. And that was £42 to top up. Plus Banana tripped over onto 211,000 miles. __________________ 233,250. And that was our first event of 2024. onen hag oll

9th April 2021, 07:34	#12509
Bob Walker Loves to post MGZT Join Date: Aug 2019 Location: Richmond Posts: 255 Thanks: 26 Thanked 80 Times in 45 Posts	V6 Thermostat I finally got around to replacing the thermostat and seals on my 190. I did it via the keyhole method a very kind and helpful member posted on this forum. The hardest part was bolting the thermostat and pipe back on the engine! 2 hours later I managed to do it! I have now got the feeling back in in my hand and arms, very little space to get hold of the bolt and the ratchet!! It is great to have a heater and no more evaporating coolant smells!! I tried not to drop the bleed valve when replacing the coolant, and guess what I did, dropped it!!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

5th April 2021, 22:13	#12504
sewerman Gets stuck in MG ZT+ CDTi Join Date: Feb 2014 Location: Wolverhampton Posts: 632 Thanks: 166 Thanked 264 Times in 154 Posts	Fit new rear lights to the tourer as the existing brackets were shot and the lenses chipped. Drivers side no trouble, passenger side PIA the sockets were broke the spares i had didn't want to hold , hopefully sorted with some silicone to stick them in will see tomorrow . Sent from my SM-G977B using Tapatalk

6th April 2021, 19:13	#12507
sewerman Gets stuck in MG ZT+ CDTi Join Date: Feb 2014 Location: Wolverhampton Posts: 632 Thanks: 166 Thanked 264 Times in 154 Posts	Fixed the tourers nearside new lamp, noticed the bumper wheel arch screw was missing so sorted that, then while i was under the car noticed the heat shield had pulled past the bolt so fit a big washer to sort that too. Sent from my SM-G977B using Tapatalk

6th April 2021, 21:13	#12508
Sheraton Posted a thing or two Rover 75 1.8t Join Date: Oct 2015 Location: Edinburgh Posts: 1,377 Thanks: 384 Thanked 409 Times in 267 Posts	Picked up Ten Lengths of CLS Timber - 2.4m lengths via the Ski Hatch - a comfortable fit with room to spare for length, and relatively secure/safe Paul.

9th April 2021, 18:07	#12510
sewerman Gets stuck in MG ZT+ CDTi Join Date: Feb 2014 Location: Wolverhampton Posts: 632 Thanks: 166 Thanked 264 Times in 154 Posts	Fitted the powerflex lower engine mount and fitted a high tone horn much better sound ! Also booked the ZT in with Tom Hobbs to get the hole fixed Sent from my SM-G977B using Tapatalk