|
||
|
15th June 2019, 10:04 | #1 |
Newbie
75 saloon Join Date: Jun 2016
Location: Preston
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
P0107 map sensor fault
Help needed!
My much loved (rarely used) 2.5v6 is showing a fault code on the map sensor. This only happened after I removed the power VIS. I removed the power vis- cleaned it and reinstalled it, the revs were high and it stalled after gentle throttle. I fear I may have caused the problem because I started the car with the vis motor disconnected. I am really annoyed as this feels like a self inflicted wound! So, I suspect that the vis motor is defective but the main problem is that it’s idling roughly and too fast- before I touched the vis motor it was fine. |
15th June 2019, 10:17 | #2 |
Give to Learn
Freelander 2 Join Date: Aug 2010
Location: West Midlands
Posts: 18,735
Thanks: 1,155
Thanked 6,407 Times in 3,874 Posts
|
HI Greg.
When you refit the power vis did you make sure the arm within the manifold was out as far as it goes, if not the peg on the vis motor may not be aligned within the arm it's self ? also remove the MAP sensor spray it with some electrical contact cleaner only, it is held in with two posidrive screws.
__________________
Arctic Givology Learn to Give Everything is Achievable ad altiora tendo. Check out our Nano meet dates http://www.midlandsnanomeets.co.uk/ http://www.the75andztclub.co.uk/index.php?thepage=howto " You do the work , we supply the expertise " Last edited by Arctic; 15th June 2019 at 10:27.. |
|
|