Redesigned bonnet cable splitter Box

[Arctic]

All that is needed is a 3mm hole through the body of the splitter box and a cable tie to pull it together enough to stop it from spreading open, thus stopping the cable clip from pulling through.

1

On the car its self.
2

3

The other two cable ties are if it did ever pull through or one of the cable snapped I could remove the wheel arch section grab the cable ties and pull the outer bonnet cable through for access.

4

The black block needs to be able to move freely inside the box.

In the past I have cut a little section out for the cable tie to hold the clip in tight.
5

Also what Sonic as suggested above was thought to be a good idea, that is until you need to remove the black splitter box from within the wheel arch, you cant because of the cable tie going through the inner body wing.