|
||
|
20th April 2020, 18:18 | #1 |
Posted a thing or two
MG ZT-T 190+,Rover 800 vitesse coupe Join Date: Aug 2014
Location: Hamilton
Posts: 1,969
Thanks: 616
Thanked 228 Times in 210 Posts
|
Changing scuttle panel
Hi looking to change my scuttle panel and I am sure there was a how to but searching I can’t find it, so any help on a walk through ?
Thanks Found Arctics old one with the images removed, are there anymore or is it simply follow his text
__________________
Robert Last edited by Robti; 20th April 2020 at 18:23.. |
20th April 2020, 20:12 | #2 |
Loves to post
Rover 75 Saloon CDTi Join Date: Aug 2012
Location: Mansfield
Posts: 287
Thanks: 18
Thanked 69 Times in 52 Posts
|
I swapped them over between my ZT and 75 a few months back.
You have to be very careful getting the retainers out. It is very easy to ping one into the undergrowth never to be seen again. Remove the 7 retainers with a small bladed screwdriver, take the rubber seal off the edge towards the engine, take the two inspection panels out and remove both wiper arms. The wiper arms are held on with a nut but will then have to be manipulated and jiggled until they come free of the spindle. Its then just a case of extract the scuttle from around the open bonnet. |
20th April 2020, 20:24 | #3 | |
This is my second home
MG ZT CDTi Join Date: Jan 2014
Location: carrick
Posts: 7,859
Thanks: 3,494
Thanked 2,657 Times in 1,973 Posts
|
Quote:
__________________
It is not gloss primer .............. it is duct tape silver! |
|
20th April 2020, 21:40 | #4 |
This is my second home
Lagoon 2.0 V6 75 Conn SE Saloon Join Date: Nov 2006
Location: Chertsey
Posts: 5,203
Thanks: 2,825
Thanked 2,920 Times in 1,570 Posts
|
Was about to post the same thing, but you beat me to it. A strip of tape along all the fasteners and if they ping out, they don't get lost .
Cliff
__________________
No. 4 of 6 |
|
|