|
|
|
|
|
|
||
|
|
||
4th July 2020, 11:33
|
#1 |
|
Posted a thing or two
Rover 75 Saloon Join Date: Apr 2019
Location: Under the car
Posts: 1,840
Thanks: 210
Thanked 244 Times in 221 Posts
|
Front hub nuts - torque question
I'm replacing the front springs & dampers, plus the top mounts & bearings. I was planning on taking the whole lot off in one go, complete with the hub assemblies - as Jules suggests in post 2 here.
According to Rave though (page 47-2) the torque for this nut is 350Nm or 258ft lbs. Is that right? If so, what does everyone use to undo the old nut? And how do you re-torque the new one later on? My torque wrench won't go anywhere near as high as 350Nm.  Pic below borrowed from Jules (link above).  |
|
|
|
|
Threaded Mode