|
||
|
11th January 2019, 23:10 | #1 |
Gets stuck in
Rover 75 Connie Tourer & Connie SE Saloon & Club SE Tourer Join Date: Sep 2014
Location: Leeds
Posts: 975
Thanks: 199
Thanked 71 Times in 59 Posts
|
White-hot brake disc
On the twisting hilly A65 I thought power seemed a bit down, then got a wobble on the steering wheel - puncture? - loose wheel? -ball joint or suspension failure?
Stopped to investigate and found a glowing hot front wheel disc; not cherry red but bright orange almost white. On thinking about it now perhaps I should have stood well clear in case it caused a fire. Sat in the car and listened to the disc hissing and creaking while I debated if the car could even be moved onto the recovery truck. After a while I felt a slight movement of the car which was parked on a slight gradient, then a little more, flnally it rolled back freely so I carried on with my 300 mile journey but using the gears and handbrake to slow down and only a very light pressure on the pedal if absolutely necessary. It now sems to be perfectly OK, but I will have the caliper off to investigate. Ironically it stuck before as I took it for mot, but the guy kindly took it off and freed it then gave me a pass. Is front caliper sticking a regular problem and what's the best preventaTive measures. I plan to drive to Sweden later and certainly would like to avoid this problem again. |
11th January 2019, 23:34 | #2 |
Loves to post
MG ZT-T 160 Join Date: Dec 2015
Location: Devon
Posts: 288
Thanks: 179
Thanked 70 Times in 53 Posts
|
I've not had a caliper stick but had a pad (inner I think?) jam so that there was uneven wear.
Given the temperature that the disk must have got to, I'd be in for a set of disks and pads at the minimum to be honest plus maybe a bleed of that caliper too. If the pad and disk were in contact in one position with the disk that hot there is likely to have been some material transfer between them which is never good. Gives the weird 'warped disk' feel under breaking I believe. Not sure how that heat will have affected the dust seal on the caliper and the piston/seal within (as well as the fluid in the caliper) but it must need a check at the minimum as you say. Could be a new caliper (or refurb the current one) is best. Also, how much heat will that have put into the bearing and ABS parts? Another unknown. Glad things seem OK now Once had a caliper jam on an old 520 E28 Beemer and the steering was wobbly...got so hot the wheel bolts had come loose! Good luck - hope it is all OK. Jonty |
12th January 2019, 09:20 | #3 |
This is my second home
Rover 75 Saloon & Tourer Join Date: Sep 2012
Location: Lincoln
Posts: 14,929
Thanks: 1,630
Thanked 3,032 Times in 2,181 Posts
|
It could be the calliper sticking on the slider pins or the piston sticking, not retracting.
I've had on a motorcycle a piston stick. Easy thing was to undo the calliper bolts macafee2 |
12th January 2019, 12:14 | #4 |
This is my second home
Rover 75 cdt club + Rover 2.5 KV6 Conni SE Join Date: May 2008
Location: Birmingham
Posts: 11,396
Thanks: 6,587
Thanked 2,262 Times in 1,729 Posts
|
We were coming back from Bude many years ago, and we always stopped at the first m/way refreshment area. My friend was in his Rover 400 series, and when we stopped side by side, I said I could smell like burning brake pads. Noticed smoke coming from his near side front wheel. When we looked it was glowing red. Boot full of the usual holiday stuff, he decided to call the RAC or AA out. When they got down to it, he said it would be interesting to find out what it was. It turned out to be a largish stone that had jammed between the disc and the brake back plate. He had not noticed anything when using the brakes.
__________________
Great Barr, Birmingham. |
12th January 2019, 13:09 | #5 |
I really should get out more.......
Rover 75 Saloon Join Date: Jul 2011
Location: Gävle
Posts: 2,537
Thanks: 395
Thanked 823 Times in 652 Posts
|
Had a rear caliper seize last year, not as hot as you describe, but too hot to touch the wheel. Had no spare at the time so exercised the piston in / out while lubricating with rubber grease. Bought a replacement from ebay at the same time but its been fine since and the new one is still in its box.
Fortunate isn’t it that you know someone in Sweden with a contact net along the main north / south E4 highway? Regards |
12th January 2019, 15:01 | #6 |
Gets stuck in
Rover 75 Tourer Join Date: Aug 2014
Location: Newmarket
Posts: 601
Thanks: 384
Thanked 130 Times in 99 Posts
|
I had a similar issue a couple of years back. On checking the operation of the piston I found I could not push it back, after some research I tried again after first loosening the bleed nipple. This time the piston slid back easily. It tuned out the brake hose had collapsed internally, preventing the piston from returning to a 'relaxed' position.
Rob
__________________
[SIGPIC][/SIGPIC] MODS DONE; plenum spyhole, bonnet cable divider block (previous owner), chrome wing mirror covers, gold fan resistor (previous owner), s/s bumper bolts, uprated under tray fittings silicone intercooler hose, Viton O rings, Crofts door finishers, boot badge, wood dash, Phil-t4's magic wand, wood wheel, mk2 repeaters, HK tweeters & Angel eye projectors. |
12th January 2019, 15:33 | #7 | |
Gets stuck in
Rover 75 Connie Tourer & Connie SE Saloon & Club SE Tourer Join Date: Sep 2014
Location: Leeds
Posts: 975
Thanks: 199
Thanked 71 Times in 59 Posts
|
Quote:
This is certainly a possibility, the stone would have dropped out when the car rolled back. But thanks for all your advice. The brakes do seem to be behaving normally now, but I will be making the usual checks as suggested. I remember it was this caliper that stuck when I took it for mot in August, but the car had been unused for a year before that. |
|
12th January 2019, 15:44 | #8 |
Loves to post
Rover 75 Saloon CDTi Join Date: Aug 2012
Location: Mansfield
Posts: 287
Thanks: 18
Thanked 69 Times in 52 Posts
|
Its just as easy to drop another caliper on there to avoid any further concern.
|
12th January 2019, 15:49 | #9 |
Gets stuck in
ROVER 75 SALOON Join Date: Apr 2017
Location: Peterborough
Posts: 597
Thanks: 386
Thanked 316 Times in 144 Posts
|
Check Wheel bearing and oil seal too.Heat and bearings aren't a good combination
|
12th January 2019, 17:16 | #10 |
Gets stuck in
Rover 75 Tourer CDTi Join Date: Jun 2017
Location: Plymouth
Posts: 695
Thanks: 141
Thanked 153 Times in 117 Posts
|
I've had this on my 1300 Fiesta a long time ago, about 20 miles into a 90mile round trip to my in-laws across Devon. Front calliper stuck on and was getting hot. causes car to drift to one side as well. I stopped and gave it a good whack with a hammer and it seemed to free up.
I carried on a (bit more slowly) using gears and the hand brake to slow down and the foot brake only when absolutely necessary. I had to fit another calliper when I got home, only cost £10 from the scrappy. |
|
|