|
||
|
11th December 2020, 12:38 | #1 |
I really should get out more.......
MG ZT 190+, Trophy Blue Join Date: Nov 2009
Location: Preston
Posts: 2,067
Thanks: 1,401
Thanked 309 Times in 195 Posts
|
Rhodium cup holder 🙏
Hi there,
The cup holder has turned its toes up. If anyone has one to sell, please let me know! Many thanks, Dale
__________________
Commission Number 352 To do list: 1. Reversing sensors 1a. Headlights polished - DONE! (Magic Mike ) 2. Auto dip rear view mirror 3. Seats replaced - DONE! (thank you Mischief) 7. Bodywork repainted 8. Inlet manifold changed for a working one - DONE! (Magic Mike ) |
12th December 2020, 12:13 | #2 |
Regular poster
MG ZTT Join Date: Oct 2010
Location: Cardiff
Posts: 95
Thanks: 46
Thanked 71 Times in 37 Posts
|
hello. i'll check for you.
I have one. pm for photos if you still need Last edited by spirit6060; 12th December 2020 at 14:07.. Reason: typo |
12th December 2020, 12:58 | #3 |
This is my second home
MG ZT CDTi Join Date: Jan 2014
Location: carrick
Posts: 7,859
Thanks: 3,494
Thanked 2,657 Times in 1,973 Posts
|
you dont need it to be rhodium, any one will do, simply replace the cover.
__________________
It is not gloss primer .............. it is duct tape silver! |
12th December 2020, 15:56 | #4 |
I really should get out more.......
MG ZT 190+, Trophy Blue Join Date: Nov 2009
Location: Preston
Posts: 2,067
Thanks: 1,401
Thanked 309 Times in 195 Posts
|
Thanks for the reply, but its the cover that has died! The plastic retaining pin has snapped so the flipping thing won't stay in
I read a thread where someone has replaced the plastic pin with a rivet, but on scrutinising, it looks way too small to fit a drill bit!
__________________
Commission Number 352 To do list: 1. Reversing sensors 1a. Headlights polished - DONE! (Magic Mike ) 2. Auto dip rear view mirror 3. Seats replaced - DONE! (thank you Mischief) 7. Bodywork repainted 8. Inlet manifold changed for a working one - DONE! (Magic Mike ) |
12th December 2020, 17:05 | #5 |
This is my second home
ZT260 #243 (resting) Join Date: May 2010
Location: Prestonpans
Posts: 22,487
Thanks: 650
Thanked 4,624 Times in 3,358 Posts
|
Dunno what size drill bit you'd need but try looking at model making supplies, I have drill bits down to 0.5mm.
|
|
|