|
||
|
23rd October 2012, 08:57 | #1 |
Regular poster
rover 75 saloon Join Date: Sep 2007
Location: belgium
Posts: 32
Thanks: 7
Thanked 1 Time in 1 Post
|
auto diesel noise at idle in drive
Hi,
When I 'm standing still in traffic in Drive at idle there is a noise coming sounds like a hard diesel knocking.When I go to N it goes away.It is no vibration. This only appears after driving some miles and the car is on temp. Auto works normal. Thanks for advice ! Peter |
23rd October 2012, 13:27 | #2 |
Passed Away
2002 Pale Blue. Rover 75 CDTi Connoisseur auto. 170K miles Join Date: Dec 2008
Location: Near the M67.
Posts: 14,509
Thanks: 199
Thanked 585 Times in 397 Posts
|
Engine mounts or crankshaft pulley, they are the biggest cause of engine knock type noises..
... |
23rd October 2012, 13:56 | #3 |
Regular poster
rover 75 saloon Join Date: Sep 2007
Location: belgium
Posts: 32
Thanks: 7
Thanked 1 Time in 1 Post
|
James,
The crankshaft pulley was changed a year ago.... Lower engine mount has been changed but know I'm 62000 miles further. Any other engine mounts that is important? Pe |
23rd October 2012, 15:59 | #4 |
Gets stuck in
rover 75 tourer auto 2001 Join Date: Sep 2010
Location: barnsley S75 6DR
Posts: 580
Thanks: 0
Thanked 1 Time in 1 Post
|
mine goes a bit quiter when put into N. Is your box noisy for the first few hundreds yards when cold?
|
23rd October 2012, 16:37 | #5 |
Passed Away
2002 Pale Blue. Rover 75 CDTi Connoisseur auto. 170K miles Join Date: Dec 2008
Location: Near the M67.
Posts: 14,509
Thanks: 199
Thanked 585 Times in 397 Posts
|
Hmmm.... when was the gearbox oil changed?
Do it yourself if it needs doing, all the waffle about exact temps is just nonsense innit. Might be worth checking the front mount drivers side, look under it for signs of hydraulic oil leaking from the damper section.. If the noise stops when you hold the wheel, there are dampers available that go inside the wheel (under the airbag) to stop the wheel rattling. ... |
23rd October 2012, 17:32 | #6 |
Gets stuck in
MG ZT CDTI +135 Join Date: Feb 2010
Location: Wilmslow
Posts: 566
Thanks: 36
Thanked 57 Times in 51 Posts
|
Where does one get the steering wheel dampers James?
|
23rd October 2012, 17:51 | #7 |
Gets stuck in
R75 CDTi Auto Conn SE Mk1 Saloon Join Date: Feb 2010
Location: Crowthorne, Berkshire
Posts: 665
Thanks: 190
Thanked 64 Times in 54 Posts
|
I did read a thread recently where a non-oem crank pulley lasted less than 6000 miles........
__________________
The only 75 with a non-factory fitted, factory fitted sunroof!!!! |
23rd October 2012, 20:42 | #8 |
Posted a thing or two
None Join Date: Feb 2010
Location: GRIMSBY
Posts: 1,243
Thanks: 0
Thanked 1 Time in 1 Post
|
|
23rd October 2012, 23:32 | #9 |
This is my second home
ZTT, Contemp Saloon, Duotone Tourer Join Date: May 2012
Location: Llandeilo
Posts: 4,192
Thanks: 290
Thanked 387 Times in 333 Posts
|
Mine was noisy in D and quite in N and R and this was down to a completely tired out lower engine mount; so perhaps see if its only in forward
This was not so evident with gear changes and so on which was pretty amazing as it looked like this |
23rd October 2012, 23:39 | #10 |
Passed Away
2002 Pale Blue. Rover 75 CDTi Connoisseur auto. 170K miles Join Date: Dec 2008
Location: Near the M67.
Posts: 14,509
Thanks: 199
Thanked 585 Times in 397 Posts
|
>>>Where does one get the steering wheel dampers<<<
Good question, maybe someone knows the answer? ?? I'm afraid I don't know.. ... |
|
|