Facelift ZT Saloon Boot Lip Spoiler-Suitable Replacement for Adhesive Tape

HJW_NI · 20th June 2019, 09:00

Hi all,

I have been root causing an issue with my number plate illumination lamps, I will need to remove the PCB assembly from the rear of the car and repair the PCB (actually I will likely just replace the PCB with wires and solder directly to the bulb holders).

The lip spoiler is held on with the 4 bolts plus additional double sided tape/adhesive strips. I want to ask the group does anyone have any recommendations for what type of tape would be good for replacing this? And where to get it?

Would the type of strip folks use for sticking on number plates do the job here, or would I need something a bit more industrial strength? If I can help it, I don't want to remove the spoiler fully until I have everything I need for putting it all back together again, so I have to admit I haven't had a good look at the tape that is there already.

Any advice would be appreciated.

Thanks all for reading.
Regards,
HW

p.s. First time posting a question to the technical forum, so hopefully I've remembered to include all the details here.

20th June 2019, 09:00	#1
HJW_NI Newbie MG ZT Join Date: May 2019 Location: Ballynahinch Posts: 12 Thanks: 5 Thanked 5 Times in 3 Posts	Facelift ZT Saloon Boot Lip Spoiler-Suitable Replacement for Adhesive Tape Hi all, I have been root causing an issue with my number plate illumination lamps, I will need to remove the PCB assembly from the rear of the car and repair the PCB (actually I will likely just replace the PCB with wires and solder directly to the bulb holders). The lip spoiler is held on with the 4 bolts plus additional double sided tape/adhesive strips. I want to ask the group does anyone have any recommendations for what type of tape would be good for replacing this? And where to get it? Would the type of strip folks use for sticking on number plates do the job here, or would I need something a bit more industrial strength? If I can help it, I don't want to remove the spoiler fully until I have everything I need for putting it all back together again, so I have to admit I haven't had a good look at the tape that is there already. Any advice would be appreciated. Thanks all for reading. Regards, HW p.s. First time posting a question to the technical forum, so hopefully I've remembered to include all the details here.