|
||
|
19th December 2020, 17:10 | #1 |
NI/ROI RS
ZT-T 190 / 75 Diesel x3 / 6 door limo / 216 Cabby / Rover 25 van Join Date: May 2009
Location: Antrim
Posts: 8,100
Thanks: 299
Thanked 1,046 Times in 568 Posts
|
A positive project for once
Presenting my 2020 lockdown project.
As some of you know my main job is working for a pharmaceutical company and my part time job is working as a none emergency ambulance driver. As you can imagine I've been mental busy in 2020 in both jobs and needed to find something to outlet my frustration with. Initially planned as a parts and scrap car as it had with massive fuel system problems and had also been the victim of a hit and run damaging rear end parked up leaving it financially exhaustive to the owner and hard to justify him doing the repairs. It was given to February time just before lockdown with the plans to rip it appart for panels, rear end etc etc. I couldn't bring myself to not try and save it, it's always been a car I admired at local events and being such low miles it felt a crime to tear it appart without trying. It looks likes someone had sabataged the car as the fuel tank was filled with sugary mess, and the fuel cap lock had stopped functioning when the car was locked which lead to all the problems. Personally I feel the car was victim of multiple attempts as I pulled out half a coal bucket of gunk from the 1st tank, without getting it all out. Biting the bullet I decided to just try a tank swap and go from there. Took a lot of work, and I got a 2nd hand tank from a running 2003 car going to scrap as it was rear ended. Lot of screwing around to get it all out on the driveway and eventually I got it in and filled it up with fuel. Ended up overhauling and replacing fuel tank, pumps, filter, blowing sludge out of the fuel lines, inlet manifold and injectors, full service, hand brake with a spare mini compensation unit and adjusted, exhaust system and a few other bits. Everything had this sweet smelling sugar blocking up the entire car and sadly it took months between two jobs to get time to sort it all. Thankfully I'd nearly all these parts spare sitting from other projects I'd owned since 2009. At this stage I was genuinely only £20 into the car for the tank only but I figured my only loss was my time. But she actually started but was very very rough. Robson Rover Repair - will it start? And then I began to notice the engine didn't sound so great...... Robson Rover Repair - sick sounding K series Initially the engine would start but ran really badly sounding like it was damaged but was top end tappet rattle, but the oil had actually separated in the engine, no doubt due to sitting for so long, so I did a flush with marine grade 4 stroke oil and proceeded to let it idol for about 30 minutes before changing oil filter as I drained it. For those who ask why, do some reading on marine grade 4 stroke oil, fantastic stuff for pulling crude out of the engine, water, moisture, etc etc. I then changed again with regular 15w40, a fresh filter and a fortes top ead treatment and she sounds like a sewing machine now. Easily quietest K series I've owned. At this stage I'd used 2 oil filters, 5 litres of quicksilver diesel marine 15w40 oil, 5 litres of 15w40 by comma oils, and then the fortes top end treatment. Now about £75 into the car, and as the engine quietened down, the rotten exhaust noise was more prevelant so a £47 back box brand new from my local autoparts solved it. Single skin but it sounds very nice. Then once it was saved and ran well I upgraded the interior with rear electric blind and swapped over all the interior trim from a contemporary 75 to offset the black and make it a touch more modern. All that's left of the damage now is shown on the wing, and I dare say a colour sand will sort that out in the summer. Ended up doing door, rear bumper, taillight and having to restraighten the boot lid hinge as it had been forced up also. Now just to fit the towbar and correct black oak gear trim when it arrives in the post. And maybe a exhaust trim seing as the replacement bumper came off a zt. Told cost to return to the road? My own man hours - About 25 Total cost - £122 (plus my own spares I had which would bring it closer to £350 but they are saved from cars I've scrapped since 2010)
__________________
Cheers, Colin Robson Rover Repair on Youtube DISCOUNTED MTEC BRAKES FOR ALL MG ROVER'S Braided hoses, more coating and pad options for 2024 |
19th December 2020, 18:42 | #2 |
This is my second home
R75 Saloon. Join Date: Feb 2009
Location: France/or Devon.
Posts: 14,003
Thanks: 3,851
Thanked 2,167 Times in 1,816 Posts
|
Well done with saving it. One less for the scrappies.
PS... Is anyone else getting these posts really large on their computer ??--On mine I have to keep scrolling across if I want to read them or see the pictures. Wondered if it was just my end causing the problems. |
19th December 2020, 23:16 | #3 |
same car since 2005
2001 Rover 75 2.0 v6 Connoisseur Saloon Join Date: Nov 2006
Location: Ellesmere Port , Cheshire
Posts: 3,810
Thanks: 379
Thanked 549 Times in 466 Posts
|
No , It is an oversize post for me too ! Happens with various posts occasionally and I wonder if it is something to do with the device the posts are sent from ?
__________________
Who said it was simples ? |
20th December 2020, 07:21 | #4 |
Avid contributor
Thinking on Join Date: Oct 2020
Location: Madeley, Staffs
Posts: 188
Thanks: 31
Thanked 37 Times in 25 Posts
|
I suppose you can see why the insurance company went for scrapping it. 25 hours by £40 an hour is £1,000 plus £350 and there's still the bodywork to put right. So heading towards £2,000 on a car that probably wouldn't fetch that much. Nice that it's been saved.
|
20th December 2020, 10:08 | #5 | |
Gets stuck in
Rover 75 Saloon BRG Join Date: Jun 2007
Location: Retford
Posts: 573
Thanks: 119
Thanked 142 Times in 69 Posts
|
Quote:
|
|
20th December 2020, 14:57 | #6 |
Gets stuck in
Ex CDT Auto Join Date: Oct 2017
Location: Barry
Posts: 655
Thanks: 76
Thanked 266 Times in 155 Posts
|
Well done, great to see you've got it running and nicely.
Just out of interest and I don't know anything about this which is why I ask, I'm sure we've all heard of putting sugar in a tank to sabotage someones engine but wouldn't the sugar also have gone into the chambers pistons etc and coated it all before initially failing. I have taken note of the flushing through with marine oil and other treatment stuff, but I'd have thought, as a non knowledgeable strapper, that a situation requiring stripping down and cleaning off of all surfaces etc etc would have been required. Good to know that you managed to flush it through without having to do this. |
Thread Tools | |
Display Modes | |
|
|