|
||
|
26th May 2014, 17:33 | #11 |
Precise
Rover 75 Tourer 2.5KV6 Connoisseur SE Join Date: Mar 2013
Location: Fleet
Posts: 2,954
Thanks: 630
Thanked 617 Times in 480 Posts
|
WD 40 is a dewatering fluid and not a very good lubricant
|
27th May 2014, 17:30 | #12 |
Posted a thing or two
Mazda MX5, BMW 520i Join Date: Feb 2007
Location: Sunny Ayrshire
Posts: 1,498
Thanks: 2
Thanked 4 Times in 4 Posts
|
When you take the wiper out of the window theres a brass (coloured anyway) collar on the spindle... The thick part. It is very hard to start moving but just keep pulling and wiggling it to take it off, give it a good clean, light grease and re-assemble.
It's just footery more than anything. Keep trying at it, it'll save you some money 👍 |
28th May 2014, 14:16 | #13 |
Newbie
Rover 75 Tourer Join Date: Jul 2012
Location: Bromley
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
JT667 - The design is such that the motor should run only with the rear window closed. Therefore, with the window open, and using a screwdriver or preferably a piece of bent stiff wire, manually move the window latch into the closed position. You will then be able to see if the motor turns the operating disc when the rear wiper switch is turned on. Remember the action is intermittent and do 'unlock' the latch in the usual way before attempting to close the window.
|
22nd March 2015, 12:48 | #14 |
Newbie
Rover 75 Connoisseur CDTi Est Join Date: Mar 2013
Location: Braintree
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
|
Seized rear wiper arm
Hi all, have to reopen this thread again as mine has seized. The motor is fine and operates without any problem. Ive removed all nuts a circlip and a small rubber seal from around the shaft, I've sprayed 3 in 1 silicone lubricant into the space between the shaft and the tube it is supposed to freely rotate in and I still can't free the shaft enough for the motor to turn it without the glass in the closed position actually moving in the tailgate.
Does anyone know how to extract the shaft from the tube without either breaking the glass or applying heat which I 'm reluctant to do. As an aside, I've found an easy way to test the motor with the window open. Slowly insert a flat bladed screw driver into the keep the rear glass striker would go into then remove it and the wiper motor thinks the window is closed, the motor should then work as normal with the window open. Before closing the window press the opening switch mounted in the handle and the keep re-opens to recieve the striker from the rear window. Do not try to close the window without pressing the opening button on the window glass to open the keep or you could damage the mechanism. Thanks Woodworkwilly |
17th November 2015, 15:53 | #15 |
This is my second home
1999 75 Connoisseur SE 2.5, 2000 75 Classic SE 2.0, 2012 Lancia Delta 3, 2016 Dacia Sandero Ambiance Join Date: Jan 2007
Location: Kilcreggan
Posts: 3,191
Thanks: 334
Thanked 334 Times in 162 Posts
|
I've just had to do mine. I was barely able to move the arm by hand. It's been fine for 4 years I've owned the car and then just started playing up in the last 24 hours.
I found that removing the wiper arm and circlip, then, with the tailgate glass horizontal, spraying some WD 40 round the spindle and leaving it over night made removal very easy. In fact, removal, cleaning, greasing up and re-assembly took less than 20 minutes this morning. I also gave the motor spindle a quick squirt of white lithium grease. My rear wiper has never worked so well, or been so quiet.
__________________
The fact there's a highway to hell and only a stairway to heaven says a lot about anticipated traffic numbers..
|
12th June 2019, 15:12 | #16 |
Newbie
75 tourer Join Date: May 2019
Location: Greenock
Posts: 14
Thanks: 4
Thanked 1 Time in 1 Post
|
Another resurrection i am afraid,,, i have the same problem on my tourer. I had the usual siezed wiper arm spindle through the glass scenario. I freed this off, still needs a bit of work though, i checked for the motor turning with tailgate open, no luck there. Then i checked the fuse, all ok. I then dismantled the tailgate trim and removed the motor to get full access to the electrical plug. I then tested for voltage. I have 10.9volts between the white and black wires, this is constant wether switch is on or off, presumably for parking. I then checked for voltage between grey and black, nothing at all. Next test is 12 volts across the wiper motor, i bet it runs, then it will be delving in to wiring etc! Does anyone know what the problem is here, or are we all running around with rear wipers that dont work?? 😎
|
19th August 2019, 12:06 | #17 |
Happy to waft not race thanks!
Join Date: Feb 2010
Posts: 191
Thanks: 196
Thanked 21 Times in 14 Posts
|
I've got to replace the wiper motor. Smell of burning when out driving and found a little smoke coming from wiper motor! Disconnected lead (burnt my wrist; very hot motor!) and ordered one from fleabay. Wiper hasn't been working for some weeks prior to this incident so maybe this had something to do with motor eventually going u/s.
|
19th August 2019, 19:02 | #18 |
Avid contributor
Rover 75 tourers(4)400turs(3 Join Date: Nov 2016
Location: Largs
Posts: 219
Thanks: 3
Thanked 67 Times in 56 Posts
|
Rear wiper not working
On all my 5 tourers the non working rear wiper has been down to a seized spindle. Cure has been to remove spindle from tube,can be a slow process, combination of chapping spindle end with a soft faced hammer ,plenty of penetrating oil and refitting the arm and trying to move it by hand(window open for this ). Patience will have its reward but it takes time.
|
|
|