Rear clamshell exhaust supplied by DMGR's

[X10Rich]

Originally Posted by elefsis

I spoke to Scott and he said he would send me an email of a fabricator in Wantage that would do the job, but no email as yet.



Anyone know of someone who could do this job I would appreciated it. I don't mind traveling.

I think I know who scott had in mind,, just north of Wantage - I puchased some bits of them a while ago, and the quality of the work he was doing on other stuff in the workshop was excellent. worth giving him a ring:-

https://www.richfabricationshop.co.uk/

I'll be using him if I need exhaust work done

[elefsis]

Originally Posted by stocktake

Having fit one of DRMGS's rear boxes I can tell you they do NOT need to be cut on the bend

Having the box put up against where it needs to be to be right in its current configuration the flare is on the bend of my existing exhaust which is an after market one, not the original. Also both pipes are the same size. It is impossible to do a simple cut and join. I would think it will need a new middle section made to order.