|
||
|
14th October 2021, 17:56 | #21 |
Newbie
Rover 75 Saloon Join Date: Aug 2021
Location: Vaasa
Posts: 15
Thanks: 0
Thanked 12 Times in 4 Posts
|
Well that was fun while it lasted. A couple of days ago I was driving my 75 for my usual commute between 2 cities (around 200kms) and at around 150km mark, the transmisson broke down again.
This time however, it made a lot of concerning thuds and shook the NAUGHTY WORD-NAUGHTY WORD-NAUGHTY WORD-NAUGHTY WORD- out of the car. I noticed how the car’s revs were stable but the speed was dropping as if I wouldn‘t have pressed the gas at all (it wasn’t an uphill or anything). I pulled over at the nearest bus stop for a break. The car did start moving, and I was able to drive it for around 15-20kms when it stopped again and wouldn‘t move at all anymore. I needed to push the car the car to safer spot and holy moly it sure is a heavy car. After a legthy tow, the car reached my mechanic, and he was astonished. He told me that he had double-checked anything that he did to it and made sure to top up the gearbox with the correct type of oil. He determined that the reverse piston and/or the friction plates were ruined again. But how this could happen again, as the gearbox didn‘t slip at all before this and I didn‘t torture the box at all. Should I get the transmisson replaced or should I still get the box repaired? It‘s ridicilous how the box only lasted around 350 kilometers of driving. Are all Rover 75 autoboxes this unreliable, or have I gotten a particularily bad one? Few weeks ago, I took the car to a different mechanic due to a check engine light, and he said that the engine cooling fan no. 2 is broken and the VIS actuators 1, 2 and 3 are stuck and therefore broken. Also, the Lambdas are giving me some kind of error code as well. So that’s a long and expensive-sounding list of faults to be fixed. Should I even bother to save this car, or should I sell it for scrap???
__________________
Owner of Conny, a 1999 model year Rover 75 Connoisseur 2.0 KV6 Auto. She was born on the 21 of April 1999 at 11:30 and was 34th car built that that day. * This vehicle was the 1,500th 75 to run off the production line, out of 112,381 * This vehicle was the 26th 75 2.0 V6 Connoisseur in Arden Green Pearlescent (JBR) with Deepsea Green interior to be made out of 545 * This vehicle was among the 24 75s in that spec that were exported to Finland |
14th October 2021, 19:02 | #22 | |
I really should get out more.......
Rover 75 Saloon Join Date: Jul 2011
Location: Gävle
Posts: 2,534
Thanks: 395
Thanked 823 Times in 652 Posts
|
Quote:
The errors stated are strange: you haven't got two cooling fans, but judging by the age of your car one fan with a three speed system. Easy to check, get yourself a copy of Toaf (use the search) and don't rely on this mechanic. And you've only got two VIS motors, again test with Toaf, I can help with renovated ones, or contact Stocktake on this group. The lambda fault might be due to lack or incorrect service, but the fan, VIS motors are relatively cheap, the gearbox replacement will cost a bit especially if you can't do it yourself but a good, condition A box must be better than fighting the one you've got. Regards Last edited by vitesse; 14th October 2021 at 19:03.. Reason: auto correct |
|
14th October 2021, 21:09 | #23 |
This is my second home
75 Contemporary SE Mk II 2004 Man. Sal. CDTi 135ps, FBH on red diesel, WinCE6 DD Join Date: May 2010
Location: Leeds
Posts: 17,273
Thanks: 2,160
Thanked 2,061 Times in 1,586 Posts
|
TOAF is here - https://toaf.roverki.eu/index.php/en/
It needs the VAG interface, but adapted for the MG/Rover.
__________________
Harry How To's and items I offer for free, or just to cover the cost of my expenses... http://www.the75andztclub.co.uk/foru...40#post1764540 Fix a poor handbrake; DIY ABS diagnostic unit; Loan of the spanner needed to change the CDT belts; free OBD diagnostics +MAF; Correct Bosch MAF cheap; DVB-T install in an ex-hi-line system; DD install with a HK amp; FBH servicing. I've taken a vow of poverty. To annoy me, send money. |
15th October 2021, 07:02 | #24 | ||
Doesn't do things by halves
Rover 75 2.5 Connoisseur Auto (1999) Dealer launch model. Join Date: Mar 2007
Location: Former Middlesex
Posts: 20,379
Thanks: 1,587
Thanked 3,749 Times in 3,181 Posts
|
Quote:
I'm very sorry to hear of your continuing problems. As Vitesse says, the JATCO automatic transmission is extremely reliable. Reverse piston failure is rare and can be replaced without any further problems. I'm afraid that in your case the prime suspect is the workmanship. Quote:
Your second mechanic's diagnostic tool has reported that the second fan speed isn't working. That's because you most likely have a 2 speed fan rather than the earlier 3 speed system so the "middle" speed isn't present on your car. You can ignore that fault code. Your two VIS actuators are inexpensive and easy to replace via this club. Almost everybody has, at one time or another, had to do this. It's a minor issue. Keep in touch Samu. Simon
__________________
"Whatever is rightly done, however humble, is noble." Sir Henry Royce. |
||
29th January 2022, 10:13 | #25 |
Newbie
Rover 75 Saloon Join Date: Aug 2021
Location: Vaasa
Posts: 15
Thanks: 0
Thanked 12 Times in 4 Posts
|
Hello,
I sure have taken my time to reply. I am only now getting back at fixing the car. I took the car to a different mechanic, and they so far have repaired the VIS motors. They were apparently full of oil and had cracked solder joints. I am wondering what kind of gearbox should I get, like is there a difference between different year gearboxes or something? My options are: 2002 2.0 V6 (same engine as mine) automatic for 150€ 2003 2.0 Diesel automatic for 200€ 2002 2.5 V6 automatic for 250€ I obviously think that I should get the newest box possible (to avoid any problems), but as you can see, my options are kind of bleak. Can I even fit a diesel automatic to my petrol 2.0 v6? Plus I am in no hurry in fixing this car. I am all in doing it just right. My 45 1.8 Kavachi serves me quite well for time being.
__________________
Owner of Conny, a 1999 model year Rover 75 Connoisseur 2.0 KV6 Auto. She was born on the 21 of April 1999 at 11:30 and was 34th car built that that day. * This vehicle was the 1,500th 75 to run off the production line, out of 112,381 * This vehicle was the 26th 75 2.0 V6 Connoisseur in Arden Green Pearlescent (JBR) with Deepsea Green interior to be made out of 545 * This vehicle was among the 24 75s in that spec that were exported to Finland |
29th January 2022, 10:30 | #26 | |
Doesn't do things by halves
Rover 75 2.5 Connoisseur Auto (1999) Dealer launch model. Join Date: Mar 2007
Location: Former Middlesex
Posts: 20,379
Thanks: 1,587
Thanked 3,749 Times in 3,181 Posts
|
Quote:
By the way, it doesn't follow that newer means more reliable. Simon
__________________
"Whatever is rightly done, however humble, is noble." Sir Henry Royce. |
|
22nd February 2022, 21:14 | #27 |
Newbie
Rover 75 Join Date: May 2013
Location: Quakers Hill
Posts: 6
Thanks: 0
Thanked 0 Times in 0 Posts
|
it failed
Our Jatco box failed at 120K mainly due to NO magnet in the sump. Rebuilding it cost $6K au plus fitting etc. ouch!
|
|
|