|
||
|
26th March 2018, 19:54 | #1 |
Regular poster
MG ZT 190+ Join Date: Mar 2017
Location: Durham
Posts: 34
Thanks: 2
Thanked 4 Times in 4 Posts
|
Power Wire Routing
All,
I have a project to put a 1500W amp in my ZT, its to consolidate 2 seperate ones i was using. I am going to be using 0AWG Cable to run to the boot and so need to find a way to route it into the cabin so i can then run doown the sides of the door trims etc The issue is getting the large cable through the firewall I posted in the ICE section but this is not ICE specific, its more a general anyone have an tips on how i can get through the FW I was using the gromet the bonnet latch cable goes through but way to small for 0AWG Have found some groomets and wires next to the ECU and the go down into the behind the arch liner area soo hoping if i get the arch liner off i can get into behind the glove box where there seems to be 2 rubber groomets for enigne and door wiring i cudl use also suggestions have been to use Step Drill bit to enlarge existing hole... Anutz! |
|
|