|
||
|
21st October 2019, 16:24 | #41 |
Doesn't do things by halves
Rover 75 2.5 Connoisseur Auto (1999) Dealer launch model. Join Date: Mar 2007
Location: Former Middlesex
Posts: 20,366
Thanks: 1,587
Thanked 3,749 Times in 3,181 Posts
|
K Seal enters the equation ...
Ahhh.
Unless I've missed it, that's the first time the devil's potion has been mentioned in this thread. Consider Pete that if this stuff has the capacity to block an oil cooler, can you imagine what it can do to smaller waterways in the cooling system such as parts of the thermostat, heater matrix and radiator? Where K-seal has been introduced, a rational explanation is elusive. I'm afraid that you face a long haul trying to rid your engine of the stuff. Simon
__________________
"Whatever is rightly done, however humble, is noble." Sir Henry Royce. |
21st October 2019, 18:18 | #42 |
Avid contributor
MG ZT Join Date: Sep 2014
Location: Westhoughton Bolton
Posts: 233
Thanks: 153
Thanked 16 Times in 14 Posts
|
Iv flushed the cooling system already about 20 times it was running fine with all the hoses getting hot and not overheating after i flushed it, if you look at my other thread when i first bought the car 'looking at buying a contemporary se v6' im sure you replied in that thread
Last edited by racing green rover; 21st October 2019 at 18:23.. |
28th October 2019, 15:09 | #43 |
Avid contributor
MG ZT Join Date: Sep 2014
Location: Westhoughton Bolton
Posts: 233
Thanks: 153
Thanked 16 Times in 14 Posts
|
I replaced the bottom hose and bled it temperature around town driving were between 89-93 although most times it was flickering between 90-92 i felt the bottom hose and it was hot not roasting but hot. I will be get a new oil cooler and stainless steel coolant rail end of this week
|
28th October 2019, 18:10 | #44 | |
Doesn't do things by halves
Rover 75 2.5 Connoisseur Auto (1999) Dealer launch model. Join Date: Mar 2007
Location: Former Middlesex
Posts: 20,366
Thanks: 1,587
Thanked 3,749 Times in 3,181 Posts
|
Quote:
Simon
__________________
"Whatever is rightly done, however humble, is noble." Sir Henry Royce. |
|
28th October 2019, 18:14 | #45 | |
This is my second home
R75 Saloon. Join Date: Feb 2009
Location: France/or Devon.
Posts: 14,003
Thanks: 3,851
Thanked 2,167 Times in 1,816 Posts
|
Quote:
Did you inspect the hose you took off ? If clear, do you think that bleeding the system again was the cure ? Last edited by COLVERT; 28th October 2019 at 20:40.. |
|
28th October 2019, 18:30 | #46 |
Avid contributor
MG ZT Join Date: Sep 2014
Location: Westhoughton Bolton
Posts: 233
Thanks: 153
Thanked 16 Times in 14 Posts
|
The old hose had the bleed screw plastic bit which sticks out of the hole damaged so it leaked a bit through past the screw. Its to early to tell if its ok like before everything was ok until the fan kicked in then it was taking a long time to cool back down to 95 and the bottom hose was cold but yesterday after i replaced the hose i runned it to 100 then the fan dropped it to 95 but that was just after i bled it before i drove it
|
28th October 2019, 21:11 | #47 | |
This is my second home
Rover 75 2.5 V6 Connoisseur SE 4dr manual Wedgewood Blue 2 04-05/06/2001 Join Date: Nov 2006
Location: N.E. Hampshire
Posts: 4,617
Thanks: 289
Thanked 308 Times in 243 Posts
|
Quote:
Will be interesting to see if the bottom hose solves all the issues. My car has had similar problems since 2012 despite my best efforts
__________________
"...the new Rover 75, which is a fabulous car......I think it looks fabulous....It's like sitting in a Rolls Royce......For me, this is the star of the show.....it looks so good" - J. Clarkson, motoring journalist on the launch of the Rover 75 in 1998. |
|
30th October 2019, 12:24 | #48 | |
This is my second home
R75 Saloon. Join Date: Feb 2009
Location: France/or Devon.
Posts: 14,003
Thanks: 3,851
Thanked 2,167 Times in 1,816 Posts
|
Quote:
Air in the V6 cooling system could have given you all those problems you had. Now with the new hose water tight the problems have gone away.--- |
|
30th October 2019, 15:24 | #49 |
Avid contributor
MG ZT Join Date: Sep 2014
Location: Westhoughton Bolton
Posts: 233
Thanks: 153
Thanked 16 Times in 14 Posts
|
Thats one leak done it has a weep from where the rubber hose going to the oil cooler attaches to the coolant rail so im getting a stainless steel coolant rail.
|
1st November 2019, 10:46 | #50 |
Avid contributor
MG ZT Join Date: Sep 2014
Location: Westhoughton Bolton
Posts: 233
Thanks: 153
Thanked 16 Times in 14 Posts
|
Yesterday when i drove for half an hour in a mix of traffic i got to my destination and felt the bottom hose it was cold the temperature of the engine was between 90-92 degrees whilst i was driving slowly going up whilst i was in traffic but dropped when car was moving again. On the way home temperature was fine again until i got stuck in traffic the temperature gradually got to 100 degrees fan kicked in but it was staying at 100 until traffic started moving again i felt the bottom hose when i got home and it was hot the heaters were always warm as well. Also when i got home i let the engine tick over but it rose to 99 degrees and was staying there it didn't rise to 100 for the fan to kick in
Last edited by racing green rover; 1st November 2019 at 15:19.. |
|
|