|
|
|
|
|
|
||
|
|
||
30th November 2020, 15:32
|
#1 |
|
Gets stuck in
75 Tourer CDTi Connie SE Join Date: Jun 2017
Location: Keith, Banffshire
Posts: 686
Thanks: 431
Thanked 132 Times in 105 Posts
|
Advice sought with ABS sensor change.
I had to change the NSF ABS sensor after the wire got damaged a while ago. As usual, the old sensor fell to pieces so I had to drill out the old one. However, after giving the new sensor a wee sand to aid with fitting, it wont sit flush at the top and doesnt seem to want to go down any further. I dont want to resort to forcing it in or bashing it but not sure how to proceed. Its got about 2-3mm further to go, i assume that if replaced back on the car as is, this would cause further problems. Any suggestions guys?
__________________
My 75 Tourer CDTi was born Saturday, 21st June 2003 @ 09:50 My 75 was the 18,749th 75 Tourer to run off the production line, out of 27,407 It was the 195th 75 Tourer CDT Connoisseur SE (135) to be made out of 2,074 and the 1,789th 75 Tourer in Wedgewood Blue Metallic (code: JEL) to be made out of 1,871 Wedgewood Blue Metallic 75 Tourers |
|
|
|
|
Threaded Mode